Front Mud Flap Install

For that factory look and extra road grime and rock chip protection Check out these Front Splash Guards from American Muscle. These Mud Flaps are made by Jaeger Brothers Automotive Accessoriesfrom ABS plastic that fit the contour of your 2010-14 Mustangs front wheel well opening.

These are not a one size fits all mud flaps you would find at your local auto parts store. This set of two Splash Guards are specifically designed to fit the front of your 2010 to 2014 Ford Mustang. They only take 10 minutes to install and work just fine along side the Roush side splitters.

Here is the spot on your Mustang where they will attach. Note this is a 2011, the 2013-14 model years have a different rocker panel molding.
Use your trim puller tool to get the push tabs out. Save your fingernails. Get the right tool.
Be sure to clean the area as the new flaps sit pressed onto this area.
The new flaps have two soft clips that press into the body molding at the top and bottom. These are high quality parts.
Slide it on, line up the holes and then put the two tabs back in.
Front Mud Flaps Repeat on the other side and enjoy your new Splash Guards
Splash Guards They should help a lot with keeping dirty water from splashing up onto your clean Mustang.
Mustang Front Mud Flap They really look good and will match with the GT500 rear splash guards
jflapsevan V6MP Member Evan B. Winner of the Jflaps set installed them on his 2011 V6 Mustang!
Splash Guards on a 2007 Mustang V6MP Member Shawn C. Winner of the Jflaps set installed them on his 2007 V6 Mustang!
No comments yet.

Leave a Reply